Usbasp firmware update jumper

Work for me. Lately, though, I have been finding different variations of the hardware. Great post. It helps understand which fuse is what! I assumed as JP2 and it worked. By the way, I installed a male jumper there for future updates! Thank you for your post. Ok I have two of those low cost USBasp burners. Now what I understand how to connect them.. But what software do I used to program it with?

The Arduino IDE?? Thanks Great day to you. How do you do this? The chip is real small. It says Atmel and there is a Thanks again. Email required.

Lincomatic's DIY Blog electronics, 3d printing, hacking, etc. March 5, at PM. April 4, at PM. May 6, at AM. May 8, at PM. PFo says:. June 21, at PM. It seems like solution of my problem. Save my name, email, and website in this browser for the next time I comment. Menu Skip to content. When your USBasp programmer prints that warning it means that firmware update is required!

Thank you. STM32 - dockerized toolchain Arduino - how to start? Good job! Hi, Thank you! Hi there! I have the same USBasp, as you mention. I put a bit of solder between the two resets pins. Im using an Arduino Mega , but 'im get stuck in the step 5, when run avrdude there's no response from the USBasp.

What I'm doing wrong? Reply 3 months ago. Oops, finally got a microscope, the chip is an ATmega8L and firmware loaded fine. Only problem: Avrdudess won't recognize it, The mfr code is wrong, but Arduino IDE will use it to upload sketches just fine. Question 1 year ago. I have a usbasp with an atmega48p and cannot compile the firmware for I believe the problem is that gcc has changed. I know that the atmega88 is in the same family, but the hex file for it is too big for the 48? Does this mean if my usbasp has an atmeg48 I won't be able to upgrade it to use with an attiny10?

Interesting instructable! Anyway, depending on the clone, it might not be a good idea to "upgrade" the firmware. Thank you for a great guide. I have almost the same programmer, just the programming jumpers are brought out so I could just use one cable to connect these correctly connected if blue led on the programmer turns off when avrdude queries the board. I did have some issues understanding how exactly to connect the wires, so when i finally managed to update the firmware, i took a few pictures.

Trying to post them here now in a hope they might help someone. Following your instructions I flashed the latest firmware usbasp. I'm pretty sure flashing worked, it successfully verified "verifying flash memory against usbasp.

However, I still get the message "warning: cannot set sck period. I'm not sure the firmware is actually the issue here Thank you for a most awesome guide Yip Yah! Dear i have one question? If i burn the atmega8. I too had the build errors, but from looking at them I think it'd be fairly easy to fix -- there'd need to be a "const" added on the lines specified.