Win setup from usb windows xp

The program will alert you before writing the USB drive. Click "OK" to continue. Please note that you'll only need the i folder. Instructions for doing so vary wildly from system to system, but generally entail the following:. Hotkey instructions are generally provided on the screen.

Assuming that it is supported as is the case with virtually all modern hardware , promote your USB drive to the primary boot device. Please notice that you can seriously screw up your system by providing incorrect BIOS settings! Depending on the speed of your USB drive, this may take a while. Is the USB device listed and does it have top priority? Have you correctly prepared the USB drive in step one?

Restart the procedure. Does your USB drive properly support being booted from? Try another one! Step 4: Prepping the Hard Disk. You need to make sure that your hard drive is partitioned and formatted properly.

Especially if you've had Linux or some other operating system on it, you'll need to repartition and format it. The rescue drive contain file manager and command line utility. You can launch DiskPart for disk partitioning and formatting from the command utility.

If you are sure that your hard drive is set up properly i. If your hard drive is partitioned in GPT mode, you also need repartition and format the disc. Enter the commands needed to repartition and format your drive. For example, try the following:. On your computer, disk 0 may not be the correct disk, you can use "list disk" to find the correct disk. With your drive all ready, you can now launch the Windows XP setup with a few custom parameters.

Remember that all USB devices will need to be plugged in right from the start while using the rescue drive. Replace C: with the drive you want to install Windows to. Proceed with the installation. The setup program will then silently close, which might make you think that something went wrong.

With your drive all ready, you can now launch the Windows XP setup with a few custom parameters. Replace C: with the drive you want to install Windows to. Proceed with the installation.

The setup program will then silently close, which might make you think that something went wrong. Don't worry though. Note: The above guide works with Windows XP only. Contact US. Make sure the "Output:" is set to "BartPE". Hit "Build". Insert the USB drive you intend to boot from.

Choose the proper writing method. Click "Start" button to start creating bootable USB drive. Instructions for doing so wildly from system to system, but generally entail the following: Reboot the system. Go to the section that contains your boot devices. Exit from the BIOS configuration, saving all changes. Does your USB drive properly support being booted from? Try another one! Step 5: Prepping the Hard Disk: You need to make sure that your hard drive is partitioned and formatted properly.

To repartition This procedure will destroy any data on the hard drive : From the Go menu, navigate to DiskPart. To format This procedure will destroy any data on the hard drive : From the Go menu, navigate to the A43 File Manager. Unplug USB drive during post stage. Change your BIOS settings back to boot from hard disk again as needed. You can now continue to finish setting up Windows XP.